Home
|
Contact Us
BKB Enterprises LLC
Office: 669 Northwood Ave, Libby, Mt 59923
Email: bkbenterprises@hotmail.com
Brent Orr (406)-293-9377...(406)-293-1998
Kelley Brown (406) 293-5467...(406)-283-1719
SET UP PROCEDURE
- Find a designated area for placement of underlayment and containment mat.
- Select an area with slope to one side so gray water can flow to transfer pump area.
- Dig a hole in an appropriate spot for mat pocket to fit into. Approximately 20X20X20 in size.
- Clear debris from area.
- Back trailer up to designated area.
- Unreel underlayment from reel and lay in appropriate area.
- Unreel containment mat and lay on top of underlayment.
- Place pocket of containment mat into previously dug hole.
- Insert barriers into pockets of mat.
- Position wash trailer so work side is toward mat and near previously dug hole.
- Place screen bucket into hole and set transfer pump in bucket. If no screen bucket is used, then place screened pump into pocket.
- Run extension cord from generator to transfer pump.
- Couple transfer hose to pump and cone tank inlet manifold.
- Level trailer using blocks and jacks.
- Chock wheels.
- Fill main reservoir with clean water.
- Fill cone tanks approximately 3/4 full.
- Remove under body wash apparatus and position onto mat in designated drive-on area (preferably closer to vehicle entrance).
- Attach hose from manifold to underbody wash.
START UP PROCEDURE
- Place bag filters into filter housings. (Preferably 100 micron filters in each housing. This may change due to earth soils at location.)
- Close filter housing ball valves located at underside of trailer.
- Open quarter inch turn relief valves at top of filter housings.
- Open outlet ball valve of main reservoir going to pump.
- Fill gas tanks for engine and generator.
OPERATION
- Check oil in motor, gear box, pump, and generator.
- Open fuel valve on underside of fuel tank.
- Crack open ball valve for underbody wash.
- Start engine and use choke when engine is cold.
- Idle control is low to medium position.
- Inspect relief valve by looking into main tank making sure it is properly set and relieves water when ball valves on
manifold are shut.
To print,
click here or select File then Print.